Gary Herrmann
12-18-2011, 5:13 PM
I got a screaming deal on a new JET JDP 20" VS metal working drill press. I got it for less than their 20" woodworking drill press goes for. 2hp. 6.5" quill travel. Auto forward and reverse for tapping. This thing is a beast. It weighs 740lbs.
Other than getting the beast down the stairs, the only dilemma is power. It's 3 phase. I was on the Factorymation page, looking at the FM50-202-C. http://www.factorymation.com/s.nl/it.A/id.196/.f?sc=2&category=32
Any reason not to go with this one? I'll still be able to use all the controls on the DP, right? Thanks for your help.
Other than getting the beast down the stairs, the only dilemma is power. It's 3 phase. I was on the Factorymation page, looking at the FM50-202-C. http://www.factorymation.com/s.nl/it.A/id.196/.f?sc=2&category=32
Any reason not to go with this one? I'll still be able to use all the controls on the DP, right? Thanks for your help.