Todd Burch
12-18-2011, 12:48 AM
Space is tight in the garage, and I figured I would go big and go vertical on this one. Plus, I have a lot of pine to use, (a lot of it birdseye pine), so for the most part, these are all pine. (Top is entirely pine, but I use some ply on the base).
First, the base.
216212 216213
The base is 6' wide and 24" deep (top is 26" wide).
I made 4 big drawers. That's a 5 gallon bucket in that drawer.
216210 216211
I didn't buy drawer slides for these drawers, even being as big as they are. I inset some white oak strips into the side of the drawers, and then ran a groove in the white oak for the drawer runner to slide on. Corresponding maple runners were glued into a dado in the case sides. With some wax, even fully loaded, they slide in and out just fine. On a couple of the drawers, I machined interior vertical grooves so dividers could be added.
216214 216215 216216 216217
Drawer fronts are birdseye pine wrapped in a mahogany.
continued...
First, the base.
216212 216213
The base is 6' wide and 24" deep (top is 26" wide).
I made 4 big drawers. That's a 5 gallon bucket in that drawer.
216210 216211
I didn't buy drawer slides for these drawers, even being as big as they are. I inset some white oak strips into the side of the drawers, and then ran a groove in the white oak for the drawer runner to slide on. Corresponding maple runners were glued into a dado in the case sides. With some wax, even fully loaded, they slide in and out just fine. On a couple of the drawers, I machined interior vertical grooves so dividers could be added.
216214 216215 216216 216217
Drawer fronts are birdseye pine wrapped in a mahogany.
continued...