View Full Version : tool rests
Jim Ketron
03-08-2005, 11:32 PM
Here is a few tool rests I made sat morning
I can use the bowl rests on anything 6" up to 20" with the 3 shown
The straight rests are 12" and 8"
all made from 1" and 7/8" cold roll steel.
Jim
Cecil Arnold
03-09-2005, 12:02 AM
They look great and I'll bet they didn't cost $25-$45 each.
Jeff Sudmeier
03-09-2005, 7:58 AM
Jim,
They look great! Looks like you will not have to make any compromises in choosing a rest to use. Each one is suited for a specific task.
Chris Lee
03-09-2005, 8:30 AM
Jim,
Any chance you want to make a couple of those to sell? They look nice. Been looking at the ones at there and they all seem pretty expensive
Chris
Glenn Hodges
03-09-2005, 9:25 AM
Look like you did a sturdy job, I wish I could find some 30mm round bar stock nearby for my Poolewood. Thanks for letting us see your handiwork.
John Shuk
03-09-2005, 7:42 PM
Look like you did a sturdy job, I wish I could find some 30mm round bar stock nearby for my Poolewood. Thanks for letting us see your handiwork.
Have soe turned down for you.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.