View Full Version : Trotec-dial indicator attachemnt

bryan henderson
12-06-2011, 2:38 PM
I made this attachment utilizing the nozzle. So the two piece of stainless steel shafts clamp on either side of the nozzle and then u screw the nozzle into the head. Using the set screw on the side of the shaft u tighten onto the attachment of the indicator to desired position.


Mike Null
12-06-2011, 3:25 PM

I don't understand what you do with this gadget or why you need it.

Ernie Balch
12-06-2011, 5:20 PM
Neat idea, Do you use it to level the table or for focus setting?


bryan henderson
12-07-2011, 8:03 AM
I use this for checking the squareness and parallelism of the datum rulers mounted on the table. Also have used this for checking concentricity and paralllelism on the rotary attachmnet. I can also throw a piece onto the table and if you require the cutting or engraving parallel to a part on a component, this ensures that it is correct.