Lathe Tool Holder Project

[Jim Young]

After getting fed up with my tools laying around I decided to make a cabinet (no doors) to put all the goodies in. Here is what I have after a few days in the shop. Half way through, I now have to make the holders themselves. At first I was going to make drawers for the cubbie holes but now I am not sure, maybe the stuff would be easier to get without having to pull drawers open.

[Jim Dunn]

How'd ya turn those triangle pieces in the ends?;)

[Robert Cox]

Judging by the size of that back panel I'm betting he used one of those outboard turning lathes.

[Jeff Sudmeier]

That looks like a nice cabinet! I would probably be inclined to put doors on the lower cubbies. To keep the sawdust out of the small parts that you will put there. Also, I would think that what you put there may have a tendancy to fall out.