Stewie Simpson
11-26-2011, 3:39 AM
Hi. On one of my previous backsaw builds I added a small piece of shaped brass plate to the bottom saw screw hole.
http://i1009.photobucket.com/albums/af219/swagman001/backsaw%20handle%20repair/IMG_0076.jpg
A larger plate that covered more of the cheek face would have been a better option at the time, so hear is the same handle after this change was made.
http://i1009.photobucket.com/albums/af219/swagman001/backsaw%20handle%20repair/PICT0021.jpg
Regards; Stewie.
http://i1009.photobucket.com/albums/af219/swagman001/backsaw%20handle%20repair/IMG_0076.jpg
A larger plate that covered more of the cheek face would have been a better option at the time, so hear is the same handle after this change was made.
http://i1009.photobucket.com/albums/af219/swagman001/backsaw%20handle%20repair/PICT0021.jpg
Regards; Stewie.