View Full Version : Versalaser V2.3 "Low Battery", "Error #2" Messages??

Steve Lautzenehiser
11-19-2011, 12:45 PM
I was wondering if anyone has had this problem. When I print, it says "low battery" and "error #2". Is the laser tube going out? I'm using a laptop which is plugged in and fully charged. I have also reloaded the driver and tried another laptop and I'm getting the same error message. Any help would be greatly appreciated.

Gary Hair
11-19-2011, 2:03 PM
Read post #6 from the following thread:

Mike Mackenzie
11-19-2011, 5:10 PM
Change the 9 Volt Battery