Shop Layout help

[Terry Starch]

I was hoping that a few of you would post a drawing of their shop layout. Im just trying to get ideas. Thanks

[Jim O'Dell]

Here is mine: 213219 The jointer at the bottom right does not exist right now, but that's where it will eventually go. The TS complex in the middle is probably a few inches to the bottom, but this is close. The room at the top right is my finishing/assembly room. It has my file cabinets, drafting table, 8 gallon portable air compressor, and some assorted junk for lack of a better place to put it. The main shop is 20 X 24. Jim.

edit: OOPS!! When I got it where I could increase the size, I noticed this is not my current TS set up. The secondary TS at the top left is now perpendicular to the main saw but at the right side of the main saw's extension table. The mobile extension table that is in that location in the drawing is behind the main TS, and there is no other table built at this time.

[Bruce Seidner]

Jim,

What drawing program did you use to share you're shop layout?