View Full Version : Skateboards
Daniel Markovich
11-17-2011, 6:49 PM
Does anyone have any experience engraving skateboards? I assume in order to engrave the whole thing you must do it in 3 sections so that each part can be positioned flat. Is there a better way?
Mike vonBuelow
11-17-2011, 10:23 PM
nope, not that I can think of - unless you just engrave the large area and call it good.
Doug Griffith
11-17-2011, 10:29 PM
look up Russel Ludwick in the forum. He's done boards.
Mike Null
11-18-2011, 8:33 AM
Have a look at these. Don't know how they were done but the designs are special.
http://www.flickr.com/photos/7259223@N05/sets/72157594580141913/?page=2
Joe Hillmann
11-18-2011, 9:35 AM
Have a look at these. Don't know how they were done but the designs are special.
http://www.flickr.com/photos/7259223@N05/sets/72157594580141913/?page=2
The way some of those cover the entire board with no break in the design where the board changes angle it looks like the wood may have been engraved as a flat piece before it was laminated to the deck.
Daniel Markovich
11-20-2011, 8:18 PM
Yeah maybe, if anyone has any other input I appreciate it, still figuring it out how to attempt it. Thanks!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.