Tail stock for nova 3000

[Harold Poland]

My tail stock went south today, I need the wheel assembly and the "keeper plate". I sent an email to nova but does anyone else stock parts for a nova tail stock? I found a dvr tail stock on amazon from "woodcrafters" Will that fit the older 3000?

Thanks

[Michael Mills]

Depending on where you sent your email it may be hit or miss.
I would try the US service center. They should have the parts without buying an entire tailstock.
4200 28th Street North
St Petersburg
FL 33714-3922
1-866-748-3025

[Sid Matheny]

Here is the link to the Teknatool USA Inc.

http://www.novatoolsusa.com/

Sid

[Andrew Kertesz]

I recently had issues with my 1624-44 and the motor pulley. While mine was covered under warranty contacting customer support was a PITA at best. After talking at length to Bob, there are only 2 people in the service center. Call the toll free number and leave a message with a number they can reach you at anytime. Direct your message to Bob as he is on the mechanical side of service, the other gentleman is electronics and I can't remember his name. Otherwise you will play phone tag.

[Michelle Rich]

while you are waiting..many tailstocks can be interchanged..I use my Nova 3000 on my Jet 1642 sometimes...

[Harold Poland]

Thanks folks. Talked to them today and the parts are on there way

[Ralph Lindberg]

Just a general note for DVR-XP vrs 3000 family. The tool-rests, tail-stocks, bed-extention, etc are NOT interchangable between the DVR-XP and the older 3000 or 3000-DVR (ie both the DVR version and regular motor version)

This is because Teknatool changed the design of the bed-rails between the 3000 family and the DVR-XP