Paul Williams from Nunavut
11-05-2011, 6:11 PM
Okay, background info: Living in Canada with standard household power setup, operating a Zing 30 watt (Epilog), along with a filter system and a blower. All three items in a bedroom-turned-into-shop.
Question: should I expect that I'm going to trip a fuse every time I try rastering/cutting, or is this unusual? Should I run long extension cords so that each item is running from different plugs, or even different rooms? Is the fact that it is tripping every time causing problems for the engraver? Should I just find a buyer and sell it all off?
I should also point out that currently (no pun intended), my engraver and air blower are operating through a Tripp Lite line conditioner, while the filter was plugged into the same outlet as the Tripp Lite.
Like the signature line says:
Question: should I expect that I'm going to trip a fuse every time I try rastering/cutting, or is this unusual? Should I run long extension cords so that each item is running from different plugs, or even different rooms? Is the fact that it is tripping every time causing problems for the engraver? Should I just find a buyer and sell it all off?
I should also point out that currently (no pun intended), my engraver and air blower are operating through a Tripp Lite line conditioner, while the filter was plugged into the same outlet as the Tripp Lite.
Like the signature line says: