Laser Master 2 Rotary table software settings not working. Help

[David Watson2]

I have a Pinnacle(mercury) (Signwarehouse) 25 w Laser with Laser 2 v7.5.

When I click in rotary in the paper tab of the print settings, there should be an x, Y , and diameter place. see:http://www.signwarehouse.com/tech-support/laser/How%20To/LM2/LM2%20-%20M%20Rotary%20Setup.pdf


T (http://www.signwarehouse.com/tech-support/laser/How%20To/LM2/LM2%20-%20M%20Rotary%20Setup.pdf)he problem is I start with x and y there, and when I click on Rotary Fixture the Y goes away totally(should just dim)

It worked months ago. Anyone had this issue ?

Have re installed once.

[Chuck Stone]

I have a similar machine, but not that software.
I'm not sure why there would even be a Y value, since you don't
use it with the rotary. The diameter measurement overrides anything
that would be in the Y dimension anyway, wouldn't it?
The "Y" position when using a rotary is always the same. There is a
correct Y position, and the machine always uses it, no matter where
your work is lined up. ie.. it's our job to get the work where the
laser beam is going to be.. unlike flat work, where we decide where
we want the laser beam to be