Paul Heely
10-10-2011, 4:53 PM
This is an almost miniature HF. At what point do we go from small to mini?
This was a small scrap of walnut that was sitting on the bench that I decided to play with. I need to make some smaller hollowing tools. I would have liked a smaller opening, but this was the smallest I could get my current hollowing tools into. Opening is 5/8", bottom is just under 1/2" and the wall thickness is 5/32". My wife thinks I need to do a whole family of these in different sizes.
209781
Species: Walnut
Size: 1-5/8" high x 1-5/8"
Finish: Gloss laquer over shellac
Thanks for looking.
This was a small scrap of walnut that was sitting on the bench that I decided to play with. I need to make some smaller hollowing tools. I would have liked a smaller opening, but this was the smallest I could get my current hollowing tools into. Opening is 5/8", bottom is just under 1/2" and the wall thickness is 5/32". My wife thinks I need to do a whole family of these in different sizes.
209781
Species: Walnut
Size: 1-5/8" high x 1-5/8"
Finish: Gloss laquer over shellac
Thanks for looking.