Joe Federici
10-10-2011, 1:17 PM
OK, I did do a little searching on this but not really finding a good answer. I have a model 31/32 retoother. This is one of the green ones not the earlier Gray. It hasn't been used in some time but I got it cleaned up along with the carriers and have used it on some older junk saws.
The issue I'm having is with the die and cutter. This being an older unit they both needed to be sharpened some time ago and now at a point where it's going to take a lot of grinding to get then square again. Does anyone know if foley is still selling parts. I tried calling them twice but not getting to a voice mail for tech support.
These units seem to pop up quite a bit from time to time so I'm sure I find a another one for parts but figured I'd see if anyone has been down this road. My next project is to get the filer working or at least see if I can. I've got a model 200 which is a little older but about the same as the 387.
Joe
The issue I'm having is with the die and cutter. This being an older unit they both needed to be sharpened some time ago and now at a point where it's going to take a lot of grinding to get then square again. Does anyone know if foley is still selling parts. I tried calling them twice but not getting to a voice mail for tech support.
These units seem to pop up quite a bit from time to time so I'm sure I find a another one for parts but figured I'd see if anyone has been down this road. My next project is to get the filer working or at least see if I can. I've got a model 200 which is a little older but about the same as the 387.
Joe