Jonathan Smith
10-09-2011, 9:30 AM
Jet combo jointer/planer
I have a new Jet jointer/planer combo and finally put it together. I haven't tried it as a planer but I have used the jointer with some snipe. That was a week ago. Now, trying to use it again I can't get it to plane at all. The knob at the end of the wing that adjusts the cut height seems to move the table up and down but it is no longer parallel with the other table. A straight edge place on in feed or out feed table goes off above the other table at a slight angle.
In other words it's slightly uphill going toward the head and/or downhill on the out feed table.
Is there another adjustment that I'm missing?
Thanks for any suggestions.
Jonathan Smith
I have a new Jet jointer/planer combo and finally put it together. I haven't tried it as a planer but I have used the jointer with some snipe. That was a week ago. Now, trying to use it again I can't get it to plane at all. The knob at the end of the wing that adjusts the cut height seems to move the table up and down but it is no longer parallel with the other table. A straight edge place on in feed or out feed table goes off above the other table at a slight angle.
In other words it's slightly uphill going toward the head and/or downhill on the out feed table.
Is there another adjustment that I'm missing?
Thanks for any suggestions.
Jonathan Smith