Chris Harper
10-07-2011, 10:37 PM
I need to trim a few rooms with 4" tall base and 3" casing. There is one small but tricky tray ceiling that I need to cut 2 3/4" tall crown for.
I have table saw sleds and a circular saw jig for most of my cross cutting so for now I'm ruling out a slider. Would rather put my money towards a sliding table for my TS.
I assume a 10" CMS will have less blade deflection than a 12" and technically I can use the 10" blades on my table saw.
So with all that said, I'm seeking recommendations for a 10" CMS, non-slider. My preferences, in no particular order:
1) Comes with the best blade possible.
2) Is easy to adjust and holds its setting. I've only had one CMS and was always fiddling with it. Ended up selling it to a friend and have never missed it.
3) Has an option for crown stops.
Cost is not a primary concern.
Thanks for any input.
I have table saw sleds and a circular saw jig for most of my cross cutting so for now I'm ruling out a slider. Would rather put my money towards a sliding table for my TS.
I assume a 10" CMS will have less blade deflection than a 12" and technically I can use the 10" blades on my table saw.
So with all that said, I'm seeking recommendations for a 10" CMS, non-slider. My preferences, in no particular order:
1) Comes with the best blade possible.
2) Is easy to adjust and holds its setting. I've only had one CMS and was always fiddling with it. Ended up selling it to a friend and have never missed it.
3) Has an option for crown stops.
Cost is not a primary concern.
Thanks for any input.