Regis Galbach
10-07-2011, 8:27 PM
Well, I've had the opportunity to begin setting up a small shop in my garage and it's going well. Have been out of ww for over 25 years and it's nice to be getting back in (even if very small shop). I've gotten some good advice here that helped and even changed my mind some. So far, after pretty good TS, a drill press, a Dewalt 618 router, and a biscuit cutter, I've just added 6" delta tabletop jointer, a Craftsman 10" bandsaw (Rikon copy) and a Bosch 1171 table. I'll have to wait a little until I get thickness planer but, am looking at Ridgid or Dewalt. I made some poor but, fortunately small purchases before reading a lot here and asking questions. Folks here have been good about answering questions and I appreciate it. Now, I just have to work on some simple projects to get all my joints and cuts sharp again. I'll be pretty much limited to making boxes and small tables.
Thanks for a helpful forum.
Regis
Thanks for a helpful forum.
Regis