View Full Version : Engraving on polycarbonate ?
Hannu Rinne
10-07-2011, 4:53 PM
I was asked to engrave a picture on polycarbonate, but I couldn't give an answer if it's possible or not... I have never tried. Should I try or not :confused: Anyone have some samples (or settings) to show ?
Cheers,
Hannu
Joe Pelonio
10-07-2011, 8:07 PM
It will not engrave as sharply as acrylic, and produces a dangerous-looking yellow smoke. Not as bad as when cutting it though. I'd stick to clipart, a photo would not show up very well.
Hannu Rinne
10-08-2011, 6:42 AM
Thank you Joe,
So I will refuse to do it :)
Regards,
Hannu
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.