Jack Gaskins
10-03-2011, 5:48 PM
When I had my riser installed I could not get enough tension on the blade. So I did what really smart thing and loosened the collars on the adjustment rod and repositioned them trying to get more tension. Well that never worked. I finally took out riser block and now need to readjust the collars back to were they were before but I can seem to get the rod to tighten or loosen very much. Can someone take a photo of there G0555 tension rod and measure where the collars are from the base of the know on the rod down to the tops of the collars. This way I will have a place to start. Another thing is I can seem to figure out why the rod wont loosen or tighten very much? Here are a few photos of my tension mech.
209063209062209061209059209060
209063209062209061209059209060