View Full Version : Current banding issue -
Doug Fennell
09-26-2011, 11:42 AM
208504208505208506
All three show banding issue in good detail... yes, last piece is chipped, good for test run :-)
epilog helix 45w
Dan Hintz
09-26-2011, 1:12 PM
Looks like the majority of banding is towards the top... that screams mechanical issue to me, like belt with a flat spot, etc.
Doug Fennell
09-26-2011, 1:28 PM
Looks like the majority of banding is towards the top... that screams mechanical issue to me, like belt with a flat spot, etc.
You very well may be right, it certainly could be mechanical. Guess I could pull the belts and flip them, just to see if I get a change in the pattern. Not sure much else could cause it - there is no play in the linear bearing (x axis) and the Y axis bearings (either side) move smoothly and have no play. Guess it could be the Y axis belt, just looking at the issue and pattern.
Dee Gallo
09-26-2011, 3:18 PM
How big a piece do you need to do? If you move the image and tile to another spot, say lower right section, would the same thing happen?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.