Ed Valasek
09-25-2011, 9:30 AM
Hello Everyone!
I have an Accuris Powersharp series engraver and noticed that the X axis is not aligned right on my unit. The display shows a postion that is off by about .1" from where it actually is on the table ruler. My jobs are all off by .1" as well. Can anyone help me figure out how to correct this? I have done the re-homing feature on the control panel but it doesn't seem to fix the issue. The Y Axis is just fine.
Thanks!
Ed
I have an Accuris Powersharp series engraver and noticed that the X axis is not aligned right on my unit. The display shows a postion that is off by about .1" from where it actually is on the table ruler. My jobs are all off by .1" as well. Can anyone help me figure out how to correct this? I have done the re-homing feature on the control panel but it doesn't seem to fix the issue. The Y Axis is just fine.
Thanks!
Ed