View Full Version : Part ?? on my Dremel 1680 scroll saw
Regis Galbach
09-15-2011, 10:25 AM
I have a Dremel 1680 scroll saw that I have not used in about 5 years. And during move from Florida to Tennessee I may have lost a part. If someone has one of these and can help me identify, I'd appreciate. In the picture it looks like the air tube would fit on the port BUT, it does not. I don't know if I am missing a connector or do I just need to heat the tube and force it over the port?
207659
Thanks from new guy on forum.
Regis
mickey cassiba
09-15-2011, 1:35 PM
No missing part...no heat needed. There is a tool available, but I've never needed it, and I've assembled yards of the stuff. I use a little natural lubricant on the male end(saliva) and a good sudden straight on push. Works every time.
HTH
Regis Galbach
09-15-2011, 2:45 PM
Thank you Mick. I'll give it a try. But, after reading posts here about the Dremel, I though I was going to have to toss it in the trash. I won't use it much so I will hang on to it.
Again, thanks for the tip.
Regis
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.