Part ?? on my Dremel 1680 scroll saw

[Regis Galbach]

I have a Dremel 1680 scroll saw that I have not used in about 5 years. And during move from Florida to Tennessee I may have lost a part. If someone has one of these and can help me identify, I'd appreciate. In the picture it looks like the air tube would fit on the port BUT, it does not. I don't know if I am missing a connector or do I just need to heat the tube and force it over the port?

207659

Thanks from new guy on forum.
Regis

[mickey cassiba]

No missing part...no heat needed. There is a tool available, but I've never needed it, and I've assembled yards of the stuff. I use a little natural lubricant on the male end(saliva) and a good sudden straight on push. Works every time.
HTH

[Regis Galbach]

Thank you Mick. I'll give it a try. But, after reading posts here about the Dremel, I though I was going to have to toss it in the trash. I won't use it much so I will hang on to it.

Again, thanks for the tip.

Regis