Nigel Morgan
09-01-2011, 1:13 AM
Hi All,
I have read here about one or two people having this problem, I have not got double nodes, no lines outside the cutting area, these are files I have cut for years, now all of sudden laser stops for a moment at a node, continues firing, it baffles me, Epilog said something must have changed in the enviroment, but nothing has, the laptop is just used to run the laser, so only windows updates installed, if these were causing the problem then no doubt Epilog would have a fix, when the laser stops for that moment there is a beep from the motherboard, any help, advice or suggestions would be appreciated.
Cheers
Nigel
I have read here about one or two people having this problem, I have not got double nodes, no lines outside the cutting area, these are files I have cut for years, now all of sudden laser stops for a moment at a node, continues firing, it baffles me, Epilog said something must have changed in the enviroment, but nothing has, the laptop is just used to run the laser, so only windows updates installed, if these were causing the problem then no doubt Epilog would have a fix, when the laser stops for that moment there is a beep from the motherboard, any help, advice or suggestions would be appreciated.
Cheers
Nigel