Tom LaRussa
02-19-2005, 11:45 PM
Spent a little more time at the old ... er ... new lathe this weekend.
Made up this set of generic old "Made In USA" socketed bench chisels.
Everybody note the nice Stanley-esque styling? :D
http://home.earthlink.net/~tomlarussa/ebay/set1-1.jpg
http://home.earthlink.net/~tomlarussa/ebay/set1-2.jpg
Also put a new handle on this hefty Ohio Tools Co. Firmer. Trust me, the handle is NOT too heavy. That blade is nearly 1/2" inch thick just below the socket.
http://home.earthlink.net/~tomlarussa/ebay/of1.jpg
http://home.earthlink.net/~tomlarussa/ebay/of2.jpg
Note: The blades in all these pics still need a wee bit of tidying up, plus sharpening, but I was just dying to share with y'all.
Made up this set of generic old "Made In USA" socketed bench chisels.
Everybody note the nice Stanley-esque styling? :D
http://home.earthlink.net/~tomlarussa/ebay/set1-1.jpg
http://home.earthlink.net/~tomlarussa/ebay/set1-2.jpg
Also put a new handle on this hefty Ohio Tools Co. Firmer. Trust me, the handle is NOT too heavy. That blade is nearly 1/2" inch thick just below the socket.
http://home.earthlink.net/~tomlarussa/ebay/of1.jpg
http://home.earthlink.net/~tomlarussa/ebay/of2.jpg
Note: The blades in all these pics still need a wee bit of tidying up, plus sharpening, but I was just dying to share with y'all.