Harish C. Mathur
02-16-2005, 12:33 PM
Has anyone tried the MLCS edge banding bits?
http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_ogee.html#1741
I'm thinking about the 60 degree set at the bottom of the link page. It looks like it would be pretty simple to set up. Any comments on them? Thanks!
http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_ogee.html#1741
I'm thinking about the 60 degree set at the bottom of the link page. It looks like it would be pretty simple to set up. Any comments on them? Thanks!