Jerome Hanby
07-10-2011, 5:08 PM
Was fitting some drawers into my wife's lathe stand (yes the same lathe stand I've been tinkering with for over two years). Worked out where to mount the cabinet part of the slides left and right and was working out the placement of the drawer part when I realized I needed something to help me repeat the placement offset to the bottom of the drawer. Couldn't lay hands on a combo square but recalled the odd job was in my box of router stuff under the router table. Worked like a champ! Think I've found a permanent resident for my right pocket to counterbalance the tape measure in my left.