did anyone notice

[charlie knighton]

did anyone notice Keith Burns debris cleaner while checking out hollowing system he was demostrating on,i really liked it, made of aluminan, nice detail, i had some green maple on the lathe today, deceided i needed one, of couse i did not have much time to be making other things than hf , my 3 minute debris remover....


anybody have a better one....i will probably make another one ....but this one works :)

[David E Keller]

Haven't seen it, Charlie... Any chance there's a photo floating around?

[Michael James]

no photo = debris still there!
I dont know how to operate that thing, but if it works then it's a good one!

[charlie knighton]

ok, i took picture, compressed file, forgot to upload, no drum roll, remember 3 minute debris remover

[Dahl Troy Perry]

Back to the picture the young girl is the gun she is holding a 22 crackshot from about 1940's ??

[Steve Schlumpf]

Charlie - I did notice! Here is a photo of Keith during his demo and a close up of his aluminum scooper tool!

199964 199963

[charlie knighton]

Back to the picture the young girl is the gun she is holding a 22 crackshot from about 1940's ??
i expect that is earlier, since that is my grandmother when she was young, Dad was the 2nd oldest and he had graduated VPI , gone to work, was in national guard then the Air Corps in the 1940s, so maybe 1915 to 1925 give or take 5 years, both of my grandmothers were named Ruby
i really do not know what type of rifle that is

[charlie knighton]

thanks Steve, that sure was a handy little gadget

anyone use anything else?????????

[Steve Schlumpf]

I use wire pipe hangers. Just bend the tips to a 45* angle to get into the forms and they work great. Here is an example: pipe hangers (http://www.ma-line.com/wire-pipe-hangers/)

[Jeff Nicol]

Just the air compressor unless I am doing a demo where I have no air. Then I have a couple chunks of vinyl tubing I shove in the HF and blow the dust out that way, just don't suck in or you get a mouth full of dust!

Jeff

[Bernie Weishapl]

I made one kind of like Keiths out of copper pipe. I made several different sizes on the ends depending on size of the opening. They do work good.

[Baxter Smith]

I did notice it Charlie. Also noticed it seemed to work a lot better than my #10 bent copper wire that I use for the curlies. The airgun handles the finestuff.

[Nate Davey]

I use my vacuum and suck it out or my compressor and blow it out into the vacuum.