Emma austin
06-29-2011, 10:11 PM
I would appreciate any help with this, I am going to make a 3D-ish sign for a friend's expo.
I have attached a pic of the logo. Also my corel file. What I want to do is cut each part seperately and then layer with tape/glue. So the white arm in the monster I will cut from white and glue on the black acrylic..
I seperated all the parts that would need to be cut, then got stuck at the squiggly line. I know it is thin but I wanted to cut this all from one piece of black acrylic. But I can't seem to make it an outline to cut? ie when I go to make it hairline, it is just one single line with no inside. It would be okay if I have to make it thicker, but short of tracing another line all the way around I can't figure out how to?
Any advice would be great! Many thanks.
I have attached a pic of the logo. Also my corel file. What I want to do is cut each part seperately and then layer with tape/glue. So the white arm in the monster I will cut from white and glue on the black acrylic..
I seperated all the parts that would need to be cut, then got stuck at the squiggly line. I know it is thin but I wanted to cut this all from one piece of black acrylic. But I can't seem to make it an outline to cut? ie when I go to make it hairline, it is just one single line with no inside. It would be okay if I have to make it thicker, but short of tracing another line all the way around I can't figure out how to?
Any advice would be great! Many thanks.