Steve Schoene
06-28-2011, 3:47 PM
We are moving, or rather movers are moving us, to a new place about 45 miles down the road, mostly expressway. My shop stuff will load from my garage, to a basement that is reached through a garage with only a six inch step up. Not too tough a move.
I'm removing the rails from my unisaw fence. (Don't want to give them easy "handles".) Should I prop up the motor with a 2x4 or the like to take weight off the belts and hence the arbor. Are there any tips on how to prop this up without creating a hazard? Remove the belts from the motor pully I suppose.
This is a 46 vintage Unisaw with a floor in cabinet, supported on a cast iron plinths.
Thanks guys, in advance.
i
I'm removing the rails from my unisaw fence. (Don't want to give them easy "handles".) Should I prop up the motor with a 2x4 or the like to take weight off the belts and hence the arbor. Are there any tips on how to prop this up without creating a hazard? Remove the belts from the motor pully I suppose.
This is a 46 vintage Unisaw with a floor in cabinet, supported on a cast iron plinths.
Thanks guys, in advance.
i