View Full Version : laser rotary attachment question

Kevin Berkshire
06-28-2011, 2:31 PM
I would like to engrave beer mugs but my problem is that you center the handle at the top and then figure out which side of the mug you want the engraving to be on, no problem so far. The real problem is that the laser height for engraving is to low and the laser will hit the handle before it rotates to start engraving. Any ideas?

Dan Hintz
06-28-2011, 2:34 PM
Does the Accuris have a "start from center" function?

Mike Null
06-28-2011, 2:57 PM
Can you elevate the item sufficiently to allow the handle to be on the bottom?

Gary and Jessica Houghton
06-29-2011, 9:45 AM
I run into this problem frequently. I have the handle slightly tilted back to allow the laser to work properly. This throws the center of the mug off, so I adjust my artwork on the screen to compensate.