Dave Lehnert
06-26-2011, 10:40 PM
This is reference my post http://www.sawmillcreek.org/showthread.php?168308-Hand-crank-bench-grinder-ID-help
I am doing a restore on this grinder. The crank has some play where it attaches to the shaft. The hole in the crank is rounded on the top and bottom but flat on the sides to match the flats on shaft. I am sure this was punched when manfactured. Is there a good way to repair this. I was thinking of just using a shim.
I am doing a restore on this grinder. The crank has some play where it attaches to the shaft. The hole in the crank is rounded on the top and bottom but flat on the sides to match the flats on shaft. I am sure this was punched when manfactured. Is there a good way to repair this. I was thinking of just using a shim.