Lisa Quinlan
06-24-2011, 12:42 PM
I have had an accuris for going on 5 years now. Have had some problems but were fixable.
It was engraving just fine and then it started engraving in the middle of a sentance very heavy, "melting the letters together". Called Tech, he had me check the tickle output, which is fine, now the printer version (have not heard back yet).
I checked the alignment and the light is scattered. I have aligned it many times but I cannot get the "scatter" to come together to the laser point.
The machine has been down all week, I have work piled and no solution in sight.
Has anyone had this problem?
Thank you in advance
Lisa
It was engraving just fine and then it started engraving in the middle of a sentance very heavy, "melting the letters together". Called Tech, he had me check the tickle output, which is fine, now the printer version (have not heard back yet).
I checked the alignment and the light is scattered. I have aligned it many times but I cannot get the "scatter" to come together to the laser point.
The machine has been down all week, I have work piled and no solution in sight.
Has anyone had this problem?
Thank you in advance
Lisa