Ben Doane
06-13-2011, 4:25 PM
I have a jointech saw train system (rails and fence system) on a contractor saw that measures 27" front to back. I would like to use the system on a new unisaw that is 31" deep. If I slide the parts out on the fence and sliding bridge to accommodate the deeper table, they will be out of the track and not able to secure them.
Has anyone been able to mount the jointech system on that TS? The Jointech website says that it will fit a 36" TS, I don't see how.
I have tried to contact customer service...........still waiting.........and waiting.
Has anyone been able to mount the jointech system on that TS? The Jointech website says that it will fit a 36" TS, I don't see how.
I have tried to contact customer service...........still waiting.........and waiting.