View Full Version : Keyless lathe chuck
Kyle Stiefel
02-10-2005, 6:27 PM
Does anybody have any experience with the Jacobs Keyless lathe chuck? I am looking to get a chuck for my lathe and would prefer a keyless but don't know if it would be wiser to purchase a keyed one.
Any thoughts?
Thanks,
Kyle
John Weber
02-10-2005, 9:03 PM
Kyle,
I have a Albrecht keyless chuck on my drill press, and it is wonderful. Very well made and it only slipped once with a 3" forstner in about 10 years.
John
John Shuk
02-10-2005, 10:23 PM
I have a keyless on my lathe. I'm very happy with it. I bought the chuck from wood craft and the taper from grizzly
Jeff Sudmeier
02-11-2005, 7:29 AM
The newer keyless chucks are much better than they used to be. Most of them tighten up normally, then if you put more force on them, they ratchet tighter. I really can't explain it, except if you use the chuck, you will know that it is a really tight hold.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.