PDA

View Full Version : Name tag cut template needed



Luke Phillips
05-26-2011, 1:04 PM
Anyone have a .CDR file of a name tag that can be used for cutting? Looking for one about 3.5"x 2" with rounded edges and the notch out for the 0.5" clear vinyl snap connector to hang from a lanyard.

Thanks!

Dan Hintz
05-26-2011, 1:15 PM
This should take about 60 seconds to create in Corel... draw a box, set the corner rounding to desired value, then add a second thin box inside for the tag loop.

Luke Phillips
05-26-2011, 1:18 PM
yes, I would do that if my PC (where the Corel app is) wasn't down for repair.

Chuck Stone
05-26-2011, 1:34 PM
will this work?

195949

Luke Phillips
05-26-2011, 2:06 PM
will this work?

195949Thanks Chuck - will let you know, when I can get it opened.

Luke Phillips
05-26-2011, 8:46 PM
After 8 hours I was able to remove a nasty virus from my computer and all seems to be intact - Chuck, thanks for the file - that will work just fine! Now to make all 300 wooden name tags!