Dan Hill
05-15-2011, 8:09 AM
I set up a job this morning hoping to get a good start on the weeks orders, sent to the Laser, focused and hit start............. nothing happened!!! Beeped like the job was finished.
Thought I missed a setting so reset all the parameters and sent again........nothing.... laser received the job, just would not do anything. Shut down, waited a bit, restarted the laser, sent it the job, ran fine for the vector - 2 short cuts. Then sent the main job, started to raster and 30 seconds into print it froze up and would not move. Could this be a stepper gone bad? Head moves freely when shut down. ULS-M300-50 almost 10 years old.
Dan
Thought I missed a setting so reset all the parameters and sent again........nothing.... laser received the job, just would not do anything. Shut down, waited a bit, restarted the laser, sent it the job, ran fine for the vector - 2 short cuts. Then sent the main job, started to raster and 30 seconds into print it froze up and would not move. Could this be a stepper gone bad? Head moves freely when shut down. ULS-M300-50 almost 10 years old.
Dan