John Leech
04-15-2003, 7:53 AM
Ok, I give up! I'm attempting my first ever loose M&T joint. Try as I might I just can't seem to get the mortise square on the piece. I've tried making a jig to rout the mortises with a guide bushing and a 1/2" bit, but one of two things happens: either the fence is not quite square or the grove in the jig (which was routed on the table to accomadate the 5/8" bushing) is crooked. What gives? Am I approaching this all wrong when there is a much easier way to do this, or is this just a case of operator error?
Thanks, John
Thanks, John