6th piece of scrap lumber....

[Rick Cicciarelli]

Still working on my turning skills. This is the 6th piece of scrap lumber I have turned since buying my first lathe. May not look like much to most of you guys, but I was happy with the way it turned out :D
190335

[John Keeton]

A multi-axis cabriole leg!! Great job, Rick! I am duly impressed. Great work on the pommel cuts, too.

[bob svoboda]

Looks like good work to me. Can't wait to see your first bowl :D

[Rick Cicciarelli]

Need to get a chuck first....thinking Vicmarc. Thanks for the compliments :)

[charlie knighton]

very nice, i believe that's the stuff Sturart Batty started out doing (stair rails), i know John Keeton was just going to make a couple table legs also

[Steve Schlumpf]

That's nice work! Clean cuts and a consistent taper! Looking good! The next challenge is to turn a matching set of four! Make sure that what ever your setup is for the first one - take the time needed to duplicate it and you will do fine! Looking forward to seeing the finished project!

[David E Keller]

Very nice! That's not an easy design to knock out cleanly, but you've done a nice job.