View Full Version : Round-over on round bench dog holes???
Jim Neeley
04-04-2011, 3:10 PM
Would a small round-over on a round dog hole reduce / preclude holding? I want to ask before I drill. <g>
I'm currently awaiting arrival of some Veritas Hold-down, Bench Dogs and Wonder Dogs. :D
Mike Nguyen
04-04-2011, 3:16 PM
I used a 45* chamfer bit and have not had any problem.
Mike
Dave Anderson NH
04-04-2011, 4:17 PM
I'm with Mike,
I used a small 45 degree chamfer to prevent having a sharp edge which could chip out.
Andrew Gibson
04-04-2011, 5:07 PM
I used an 1/8" radius round over on mine and have no probles. I think it looks good as well.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.