PDA

View Full Version : Led Problem


sal shepherd
03-30-2011, 9:57 PM
Good evening, I purchased some led strips from superbright leds ( FLB-30 ). I also
got the adpt cables. These are all 12 vdc. I attached my 12 v batt. nothing happends. The adpt is red wire+ black- , the cable only plugs in only one way. I checked 2 other strips no luck. Emailed company 2 days ago, running out of time.
Checked bat. voltage ok.
Any idears???
Robert Walters
03-30-2011, 11:34 PM
If you have a meter, test for conductivity in the cable(s) and the strip itself.
Doug Lynch
03-31-2011, 10:53 AM
I bought some LED strips not long ago that were marked wrong. In that case the Red was - and the black was +.

Doug
Chris DeGerolamo
03-31-2011, 11:10 AM
I bought some LED strips not long ago that were marked wrong. In that case the Red was - and the black was +.

Doug

"inflammable means flammable??"
sal shepherd
03-31-2011, 1:27 PM
Doug you were right on. I figured last night to flip wires I had a dead line and going for broke. I did this a wile back and blew them.
Now for the hard part making the bases for the top which is a 3 layer flame and bottom the easy one with single layer.
picts to come when done
Thanks Everyone