PDA

View Full Version : Circular alignment of lines in Corel Draw



Mike Lassiter
03-30-2011, 12:41 PM
I suspect this will be so easy when someone advises how it's done. I am needing to position lines in a circular array similar to a clock dial. Somewhere I have saw the answer to this that shown how to do it. I believe it allowed you to specify how many lines to evenly position around the circle. Not sure about placing them a specific number of degrees apart like step and repeat except in a circular pattern.

I have searched in Corel help and manual as well as looked in Corel Unleashed X4 and not found an answer.

I appreciate any guidance.

Mike

Robert Walters
03-30-2011, 12:46 PM
http://www.engrave.ca/archives/588#more-588

Mike Lassiter
03-30-2011, 12:59 PM
Thank You Robert!
An answer in 5 minutes for what I have spent seveal hours all together trying to figure out on my own.

John Noell
03-30-2011, 3:07 PM
An even easier way to do it is use the radial array macro (which was written by Aaron here at the creek I think).