Amos De Pasquale
03-30-2011, 7:20 AM
189044189043I own an OmniSign Pro 3000 machine, it has an 80 Watt tube.
At present it runs on LaserCut 5.1 Software, but I want to run it with LaserCut 5.3 ; The Sellers of the machine have given me the software, however, after loading the software, the software will not allow any mechanical movement,:confused: it is as if the software is not talking to the MPC6515 card controller in my computer. Has anyone here successfully upgraded to Lasercut 5.3 ???? I have added photos of the error message,
Advice would be appreciated, Amos
At present it runs on LaserCut 5.1 Software, but I want to run it with LaserCut 5.3 ; The Sellers of the machine have given me the software, however, after loading the software, the software will not allow any mechanical movement,:confused: it is as if the software is not talking to the MPC6515 card controller in my computer. Has anyone here successfully upgraded to Lasercut 5.3 ???? I have added photos of the error message,
Advice would be appreciated, Amos