Greg Bednar
03-21-2011, 2:38 PM
I've noticed two things:
1) When entering raster values, I am able to directly enter
speed and power settings into the box with no problem.
When directly entering vector values in the Dashboard,
I can directly enter the values in Power and Speed, but
I cannot directly enter values into the frequency box;
I have to use the slider or bump up or down with the + or
- key respectively.
2) When rastering and while setting raster power settings
on the fly at the machine, as I drop the power down from 48% in 1% increments,
it will go to 47%, 46% but then skip 45% and go directly to 44%
I've sent an email to Epilog
I don't know if this is a driver or a firmware problem or both. But presents
nothing major at this time.
1) When entering raster values, I am able to directly enter
speed and power settings into the box with no problem.
When directly entering vector values in the Dashboard,
I can directly enter the values in Power and Speed, but
I cannot directly enter values into the frequency box;
I have to use the slider or bump up or down with the + or
- key respectively.
2) When rastering and while setting raster power settings
on the fly at the machine, as I drop the power down from 48% in 1% increments,
it will go to 47%, 46% but then skip 45% and go directly to 44%
I've sent an email to Epilog
I don't know if this is a driver or a firmware problem or both. But presents
nothing major at this time.