Joe Bradshaw
03-19-2011, 10:51 PM
This is a little gadget that I made to assist in setting the laser on my Mini-Monster. I set it on my toolrest and put the cutting tip against the cut-out area. I scribed some lines on the top to aid in setting the laser. On the other end, I drilled a hole large enough to insert a 1/4" cutting tip. I drilled and tapped a hole for an allen screw which holds the cutting while sharpening. The gadget is made from alum. and is about 3/4" square by 2" long. It does well when sharpening and keeps you from burning your fingers.
187376
187376