john passek
03-18-2011, 1:35 AM
Hello Creekers
I tried a search but didn't find an answer to my problem.
I don't use the rotary very often but it has always worked when I needed it, until recently.
I plugged it in and turned on the laser but the laser would not register the rotary was hooked up.
I unplugged and replugged several times, checked the connections, wires, pins in the plugs but can't find anything obvious.
I reloaded the driver when all else failed and that didn't fix it.
I talked to Koy from epilog support and did what he suggested to check but no luck.
Has anyone else had this issue,
Thanks for any assistance.
I tried a search but didn't find an answer to my problem.
I don't use the rotary very often but it has always worked when I needed it, until recently.
I plugged it in and turned on the laser but the laser would not register the rotary was hooked up.
I unplugged and replugged several times, checked the connections, wires, pins in the plugs but can't find anything obvious.
I reloaded the driver when all else failed and that didn't fix it.
I talked to Koy from epilog support and did what he suggested to check but no luck.
Has anyone else had this issue,
Thanks for any assistance.