James Meehan
03-14-2011, 1:54 PM
Hi, I was hoping someone might be able to advise me on how I would match the moulding detail (first picture) on the original table rail?
I have matched the pattern as best I could and then band sawed to shape. I don’t have a spindle moulder only hand tools and a few machines, also power tools mainly routers.
At first I was asked to repair and then refinish the original oak table, but then I was asked if I could make a smaller table that matched.
186776 186780 186777 186778
I may in the future have to match the moulding detail in the pictures below again any advice would be very much appreciated.
186779 186781 http://www.sawmillcreek.org/images/misc/pencil.pnghttp://www.sawmillcreek.org/images/misc/pencil.pnghttp://www.sawmillcreek.org/images/misc/pencil.png
I have matched the pattern as best I could and then band sawed to shape. I don’t have a spindle moulder only hand tools and a few machines, also power tools mainly routers.
At first I was asked to repair and then refinish the original oak table, but then I was asked if I could make a smaller table that matched.
186776 186780 186777 186778
I may in the future have to match the moulding detail in the pictures below again any advice would be very much appreciated.
186779 186781 http://www.sawmillcreek.org/images/misc/pencil.pnghttp://www.sawmillcreek.org/images/misc/pencil.pnghttp://www.sawmillcreek.org/images/misc/pencil.png