Scrollsaw mounting question

[Jerome Hanby]

I found a Shopfox tool stand on the local craigslist for next to nothing a while back and finally got around to putting it together. It looks like it was tailor made for my wife's scrollsaw. I found a maunal for the saw online to see if they had mounting recommendations and they mentioned (optionally) using a rubber pad between the saw and table. That didn't sound like a bad idea. My question, would the anti-fatigue mats (that run $12 for a set of four at HF) work for this? I know I've see rubber mats before, but for the life of my I can't think of where to buy them.

Thanks.

[Jim Finn]

I use four of those harbor freight foam sanding pads. Works like a charm.

[Charles McKinley]

I would also condiser putting a sand bag on it to help absorb the vibration.

[Jerome Hanby]

I use four of those harbor freight foam sanding pads. Works like a charm.

Are these (http://www.harborfreight.com/catalogsearch/result?category=&q=foam+sanding+pad) the ones?