Rolf Schmid
01-24-2005, 11:41 AM
The metall work of plane #10 is done.
The body is milled of solid brass.
The Plane irons are 6mm thick (A2) and cryotreated . The iron can be aligned with two screws on each side.
The irons will be surfaceground the next days. At the picture you can see the milling marks.
The mouth is adjustable. This is the difference to the LN plane.
The lever cap will be redesigned, a little bit shorter and the wooden knob is missing.
more pictures (http://www.hobel-und-eisen.de/holz/HObel/einhandsimshobel.htm)
regards
Rolf
http://www.hobel-und-eisen.de/holz/HObel/P1010827k.jpg
The body is milled of solid brass.
The Plane irons are 6mm thick (A2) and cryotreated . The iron can be aligned with two screws on each side.
The irons will be surfaceground the next days. At the picture you can see the milling marks.
The mouth is adjustable. This is the difference to the LN plane.
The lever cap will be redesigned, a little bit shorter and the wooden knob is missing.
more pictures (http://www.hobel-und-eisen.de/holz/HObel/einhandsimshobel.htm)
regards
Rolf
http://www.hobel-und-eisen.de/holz/HObel/P1010827k.jpg