Help with router bit

[larry bailey]

Can anyone help me locate a router bit with the same profile as in my pic. This one appears to have two different size radii on the round overs, but all of the bits I've found have the two of the same. Thanks - Larry



186272

[Darrin Davis]

Maybe it's pre-made molding. When I want something like that I usually use 2 different pieces of wood. Put the first one on and then add the 2nd one on top of the first.

[Myk Rian]

Either 2 pieces of wood, or 2 router bits.
3rd choice, a shaper with custom knives.

[Tad Capar]

This looks to be made with moulder as one piece. You can try this http://www.razorwoodworks.com/index.php?page=shop.product_details&flypage=flypage.tpl&product_id=148&category_id=62&option=com_virtuemart&Itemid=1 (http://www.razorwoodworks.com/index.php?page=shop.product_details&flypage=flypage.tpl&product_id=148&category_id=62&option=com_virtuemart&Itemid=1)
I have one of these and I like it a lot. You can use just two larger radius' (cut off the small one). You may have to round over (3/8"R) one of the edge to make it look like your picture, if I'm looking at it right. Hope this helps.

[Bobby Knourek]

can make you a router bit in 24 hours to match that profile.
just fax a cutaway tracing 715 662 5801 or e.mail info@woodworkerstoolworks.com
all work is guarenteed.

Bobby.

[Brian Gumpper]

If you want to do that yourself, you're probably going to end up with a custom router bit and an applied molding. I have something similar in my house and it's one piece which means they were made on a molding machine. For high volume door makers, it's the only way to go.